cRPG
cRPG => Suggestions Corner => Game Balance Discussion => Topic started by: mulas on May 15, 2011, 07:50:37 am
-
Today I found out the Highland Claymore length was reduced from 120 to 117....
Can you please add 1 speed to it? Shorter weapons usually are faster. It's only fair right?
-
Yes and reduce the damage down to 40 to make it even fairer. :wink:
-
yeah make it unbalanced, lower the thrust from the OP 22 pierce to... 17 pierce maybe. so it can bounce even on peasants.
oh also lower the cut damage to.. hmmm... 35c. so we all retire to polearms and put this comedy to an end.
-
3 reach is hardly a nerf. It should have the grip point still higher and its reach shortened. With the right grip I think the reach of the current mesh would be something like 112-114. It does significantly more cut damage than the other swords while keeping the same speed. I'd say it is a good tradeoff.
Shorter *often* means quicker, but not always. The historical piece was shorter heftier and more of a chopper than the continental equivalents. This trend is currently reflected in the stats.
-
Acting like you didnt know this would happen is against any common sense.
-
lower the thrust from the OP 22 pierce to... 17 pierce maybe. so it can bounce even on peasants.
oh also lower the cut damage to.. hmmm... 35c. so we all retire to polearms and put this comedy to an end.
I laughed a minute to this.
And now I'm sad :(
-
No, adding 1 speed would make it the most OP weapon in the game, the nerf was bound to happen since after the patch it became the power cutter of choice for most people. The stats now are fine
-
No, adding 1 speed would make it the most OP weapon in the game, the nerf was bound to happen since after the patch it became the power cutter of choice for most people. The stats now are fine
If you all dont know, he is one of these powercutters!